Wireless relay ABR 102 with dimming and repeater function

AFRISO Smart Home Produkt Funk Einbaurelais ABR 102 mit Dimm Funktion
  • Dimming of LEDs and other lamps of type RLC up to 180 W
  • From 180 W to 1,150 W / 5 A: switching function
  • Automatically determines the dimming characteristic of the lamp
  • Support deep dimming of LEDs (dimming values up to 1 %)
  • ECO mode: actuator send signals only after request or state change

Application

For remote switching/dimming of lamps and for power measurement of the connected devices. Repeater function levels 1 and 2. Suitable for direct installation in in-wall junction boxes or lamps due to the small size. Approved loads: retrofit LEDs, AC-dimmable LED controllers, low-voltage halogen lamps with electronic and wound transformers, high-voltage halogen lamps and filament lamps.

Description

The wireless relay ABR 102 can be used for dimming and switching of lamps. The wireless relay automatically determines the dimming characteristic of the lamp and allows for dimming down to 1 % of the maximum power of the lamp. If the load exceeds 180 W, the dimming function is deactivated. The connected electrical equipment can be switched on and offer. The wireless relay allows for teaching in up to 30 EnOcean® sensors. This includes, for example, switches, window contacts, the water sensor eco, presence detectors or card switches. The wireless relay can be used in parallel with conventional switches and three-way switches. Existing circuits become part of a building automation system. The relay can also be operated as a component of the AFRISOhome gateway. This enables remote control via mobile devices.The wireless relay also features a power metering function to measure the power consumption of connected equipment on an ongoing basis as well as a repeater function.

Technical specifications

Operating temperature range
Ambient/operation: -10/+25 °C

Relative humidity
0–95 % r.h. (non-condensing)

Supply voltage
AC 207–253 V
Frequency: 43–67 Hz
Maximum power
Dimming: 180 W
Switching: 1,150 W max 5 A, cos ø > 0.3
Power dissipation standby: < 0.5 W
Service life of relay contacts: > 50 x 103 cycles

Protective functions
Overcurrent: Switching off of load
Overtemperature: Switching off of load

Housing
Colour: White, similar to RAL 9003
W x H x D: 27 x 17.5 x 37 mm
Weight: Approx. 26 g

Power/energy measurement
Power: Active power in W
Accuracy: < 5 %, at least 1 W

EnOcean® wireless
Frequency: 868.3 MHz
Transmission
power: Max. 10 mW
Range: 10 to 30 m (depending on room arrangement and materials in the building)

Standards
As per EN 60669-2-1
The device may be damaged in the case of
a short circuit at the output.